Toy Remote Control Aircraft Installation And Maintenance.doc 27 Pages

XỔ SỐ BA MIỀN 2023年11月02日 04:44 42 admin

Remote Control Aircraft Maintenance Information (Basics) Accessories: 1. Main fan blades: Main fan blades are divided into upper and lower fan blades. Generally, the two types of fan blades cannot be mixed. They must be seated according to the number. The upper and lower blades are distinguished according to the numbers or numbers on the fan blades. Letter recognition upper blade diagram: lower blade diagram: 2, balance bar: 3, main blade splint: 4, connecting buckle: each aircraft, one or two connecting buckle 4, casing: also known as the nose cover 5, Landing gear: 6, tail pipe assembly: 7, tail trim: 8, tail fin: The above accessories are commonly used in aircraft, and they can all be ordered in the disassembly and assembly section: (The aircraft used in the case is T14, the accessories of the aircraft and The installation is similar) Disassembly and assembly of the connecting buckle: When disassembling, just push it outwards to remove one end first, and then the other end. Disassembly and assembly of the balance bar: When the aircraft balance bar breaks, it will affect the normal flight of the aircraft. This will affect the normal flight of the aircraft. All you need is a new balance bar. The balance bar is usually fixed on the aircraft by a metal shaft (T-shaft). Use a small screwdriver to push out the T-shaft. Sometimes you need to use a hammer or other tools to remove the T-shaft. After taking out the T-shaft, put on a new balance bar and align the center part of the balance bar with the rotation axis of the aircraft to facilitate the installation of the T-shaft. Insert the T-shaft into the hole corresponding to the connecting buckle and the rotation shaft. This is Be sure to pay attention to the connecting buckle joint corresponding to the balance rod and the upper wind blade splint. Use pliers to pass the T-shaft through the rotating shaft to connect the balance rod and the rotating shaft together. That is, the installation of the fan blade splint assembly and the main air flow are completed. Installation of the Blades The picture below shows the aircraft with the blades and their splint components removed. Pass the lower blade splint assembly around the fixed frame of the upper blade and connect it to the lower splint. When winding, choose a good angle to connect the upper and lower splints. After docking the plywood, start installing the lower fan blades. Place the lower fan blades in the corresponding connection slots and fasten the plywood. At this time, you can screw up the screws one by one. Add screws to the fan blades and screws to the plywood. , after all the plywood screws are installed, the downwind blade and the plywood are installed. When installing the upwind blade assembly, the splint should also be bypassed once. Place the lower assembly corresponding to the main rotation axis and install the upper plywood. The two plywoods are butted to install the upwind blade and downwind blade. The installation method is the same as the installation of the nose cover: when the nose cover is damaged or broken, you can replace it with a new one. Install the nose cover correspondingly with the aircraft. Pay attention to the searchlight below the aircraft.

标签： Aircraft Plywood Balance Installation Components